OpenBSD 5.8 發布預覽,計劃10月18日正式推送

jopen 9年前發布 | 7K 次閱讀 OpenBSD

OpenBSD 5.8 發布預覽,計劃 2015 年 10 月 18 日正式發布。

OpenBSD 5.8 發布預覽,計劃10月18日正式推送

主要改進如下:

  • 改進硬件支持:

    </li>

    • New rtwn(4) driver for Realtek RTL8188CE wifi cards.

      </li>

    • New hpb(4) driver for HyperTransport bridges as found in the IBM CPC945

      </li>

    • The ugold(4) driver now supports TEMPerHUMV1.x temperature and humidity sensors.

      </li>

    • Improved sensor support for the upd(4) driver for USB Power Devices (UPS).

      </li>

    • Support for jumbo frames on re(4) devices using RTL8168C/D/E/F/G and RTL8411, including PC Engines APU.

      </li>

    • re(4) now works with newer devices e.g. RTL8111GU.

      </li>

    • Partial support has been added for full-speed isochronous devices in ehci(4), allowing USB 1.1 audio devices to be used on EHCI-only systems in some cases.

      </li>

    • Improved macppc stability and G5 performances with MP kernels

      </li>

    • acpicpu(4) uses ACPI C-state information to reduce power consumption of idle CPUs.

      </li>

    • Kernel supports x86 AVX instructions on CPUs that have them.

      </li>

    • Avoid assigning low address to PCI BARs, fixing various issues on machines whose BIOSes neglect to claim low memory.

      </li>

    • wscons(4) works with even more odd trackpads.

      </li>

    • Added pvbus(4) paravirtual device tree root on virtual machines that are running on hypervisors.

      </li>

    • New octdwctwo(4) driver for USB support on OpenBSD/octeon.

      </li>

    • New amdcf(4) driver for embedded flash on OpenBSD/octeon.

      </li>

    • ...

      </li> </ul>

    • 移除的硬件支持:

      </li>

      • The lmc(4) driver for Lan Media Corporation SSI/T1/DS1/HSSI/DS3 devices has been removed.

        </li>

      • The san(4) driver for Sangoma Technologies AFT T1/E1 devices has been removed.

        </li>

      • ...

        </li> </ul>

      • 常規網絡棧改進

        </li>

        • MTU of vlan(4) devices can now be set independently from the parent interface's MTU.

          </li>

        • The same network range can now be assigned to multiple interfaces, using interface priorities to choose between them.

          </li>

        • New  MPLS pseudowire driver mpw(4).

          </li>

        • ...

          </li> </ul>

        • 安裝器改進

          </li>

          • hostname-mode.conf response file names.

            </li>

          • response files to be placed in a subdir of the webserver's document root.

            </li>

          • passing a template file to        disklabel(8)        to automatically partition the disk.

            </li>

          • The default answer is now 'no'.

            </li>

          • 'prohibit-password' has been added to the list of possible answers.

            </li>

          • The logic of the 'Allow root ssh login?' question has been changed.

            </li>

          • autoinstall(8)      has been extended to allow

            </li>

          • ntpd(8)      is now enabled by default at install time.

            </li>

          • DUID support has improved enough that new installs now use them unconditionally.

            </li>

          • Installing sets from CD-ROM has been fixed if more than one CD-ROM drive is present.

            </li>

          • The 'Which CD-ROM contains the install media?' question has been removed.      Available cdrom devices are now shown directly in the 'Location of sets?' prompt.


            </li> </ul>

          • 安全改進:

            </li>

            • sudo in base has been replaced with doas(1), sudo is available as a package.

              </li>

            • file(1) has been replaced with a new modern implementation, including sandbox and privilege separation.

              </li>

            • pax(1) (and tar(1) and cpio(1)) now prevent archive extraction from escaping the current directory via symlinks; tar(1) without -P option now strips up through any ".." path components.

              </li>

            • Improved kernel checks of ELF headers.

              </li>

            • ...


              </li> </ul> </ul>

              詳情請看發行說明更新日志

              OpenBSD是一個從NetBSD衍生出來的類Unix操作系統。專案領導人Theo de Raadt在1995年]發起了OpenBSD專案,希望創造一個注重安全的操作系統,此外OpenBSD也以高品質的文件、堅持開放程式碼以及嚴格的軟 件授權著名。OpenBSD的吉祥物是河豚。

              OpenBSD包含了一些在其他操作系統缺少或是選擇性的安全功能,此外OpenBSD極度重視程式碼的品質,任何對核心的修改都需要經過嚴格的程 式碼審閱。OpenBSD可以在17種不同的硬件環境下運作,包含DEC Alpha、Intel i386、Hewlett-Packard PA-RISC、AMD64、Motorola 68000、PowerPC、Sun SPARC等。

              OpenBSD 5.8 發布預覽,計劃10月18日正式推送

              來自:http://www.oschina.net/news/65399/openbsd-5-8-available-for-pre-order

               本文由用戶 jopen 自行上傳分享,僅供網友學習交流。所有權歸原作者,若您的權利被侵害,請聯系管理員。
               轉載本站原創文章,請注明出處,并保留原始鏈接、圖片水印。
               本站是一個以用戶分享為主的開源技術平臺,歡迎各類分享!